Types of contaminated water requiring disposal
Contaminated water can arise during routine operations, maintenance, construction work or following an unexpected incident. Common situations include:
- Fuel and oil contaminated water, including rainwater collected in bunds or affected by a spill
- Firewater run-off containing combustion residues, chemicals or materials washed from an affected building
- Wash bay effluent and liquid waste removed from interceptors and silt traps
- Water collected in flooded basements, pits, chambers and lift shafts where contamination is suspected
- Contaminated groundwater pumped from excavations, construction sites or remediation works
- Tank, vessel and pipework washings produced during cleaning or decommissioning
Each source presents different considerations. Water from a known industrial process may have a relatively consistent composition, while firewater, excavation water and floodwater can contain an unpredictable mixture of substances. That difference affects sampling, storage and the treatment options available.
Waste classification and sampling
Waste classification starts with the process that produced the liquid and the substances it may contain. Existing process information, chemical records and relevant laboratory analysis can help establish the appropriate List of Waste code and hazardous status.
Where the composition is uncertain, representative sampling and appropriate chemical analysis may be required. Sampling should account for the nature of the liquid, including whether oils, suspended solids or settled material are present. A single sample from the surface of a tank may not describe the full contents accurately.
Aqueous liquid wastes containing dangerous substances may fall under hazardous waste code 16 10 01*, depending on their source and composition. Oily water from an interceptor is classified as 13 05 07*, while interceptor sludges and solids have separate hazardous waste codes.
Where a liquid waste stream may be non-hazardous, its classification still needs appropriate supporting information. The non-hazardous waste classification service covers the assessment of waste streams that do not require hazardous classification.
Landfill waste acceptance criteria results are not a substitute for waste classification. Hazardous waste must also be kept separate from incompatible or non-hazardous waste unless mixing is specifically authorised under the applicable regulatory requirements.
Containment before collection
Contaminated water needs suitable containment while its classification and disposal arrangements are established. Depending on the circumstances, this may involve existing tanks, bowsers or other containers suitable for the liquid and the contaminants present.
The available storage capacity, liquid level, access arrangements and potential for further water entering the containment area all need consideration. Rainfall can increase the volume held in open excavations and exposed bunds, while settled material may affect how a tanker can remove the contents.
Different liquid waste streams should remain separate where their composition or classification differs. Mixing them can complicate classification, affect treatment options and create additional handling requirements.
Storage away from the site where the waste was produced may require an appropriate environmental permit or registered exemption. The applicable requirements depend on the storage activity, location and regulatory jurisdiction.
Tanker collection and waste documentation
Tankering is a common method of removing contaminated water from tanks, bunds, pits and other containment areas. Collection arrangements depend on the liquid’s properties, the volume involved, site access and the receiving facility’s acceptance requirements.
Businesses transporting waste must hold the appropriate waste carrier registration. The waste holder should check the carrier’s registration and confirm that the receiving facility is authorised to accept the relevant waste.
In England, hazardous waste movements require a consignment note. The producer or holder completes parts A and B, the carrier completes part C, the consignor completes part D and the receiving facility completes part E. The note accompanies the waste to its destination.
Non-hazardous waste movements generally require a waste transfer note or other legally acceptable transfer documentation. The description should correctly identify the waste and provide sufficient information for its handling and treatment.
Waste descriptions include the classification code, hazardous status where applicable, source premises, production process, relevant substances, chemical and physical characteristics and any particular handling requirements.
Hazardous waste producers in England must retain the relevant consignment records and consignee returns for three years at the premises concerned. Documentation and administrative procedures differ across Scotland, Wales and Northern Ireland, so the requirements applicable to the waste’s location and movement must be followed.